Thermal analysis of the FSP-1 experiment in the advanced test reactor

The U.S. High Performance Research Reactor Conversions fuel development team is focused on developing and qualifying the uranium-molybdenum (U-Mo) alloy monolithic fuel to support conversion of domestic research reactors to low enriched uranium. Several previous irradiations have demonstrated the favorable behavior of the monolithic fuel. The Full Scale Plate 1 (FSP-1) fuel plate experiment will be irradiated in the northeast (NE) flux trap of the Advanced Test Reactor (ATR). This fueled experiment contains six aluminum-clad fuel plates consisting of monolithic U-Mo fuel meat. Three different types of fuel plates with matching pairs for a total of six plates were analyzed. These three types of plates are: full burn, intermediate power, and thick meat. A thermal analysis has been performed on the FSP-1 experiment to be irradiated in the ATR at the Idaho National Laboratory (INL). A thermal safety evaluation was performed to demonstrate that the FSP-1 irradiation experiment complies with the thermal-hydraulic safety requirements of the ATR Safety Analysis Report (SAR). The ATR SAR requires that minimum safety margins to critical heat flux and flow instability be met in the case of a loss of commercial power with primary coolant pump coast-down to emergency flow. The thermal safety evaluation was performed at 26 MW NE lobe power to encompass the expected range of operating power during a standard cycle. Additional safety evaluations of reactivity insertion events, loss of coolant event, and free convection cooling in the reactor and in the canal are used to determine the response of the experiment to these events and conditions. This paper reports and shows that each safety evaluation complies with each safety requirement of the ATR SAR.