Improving the accuracy of PCMI simulations with more realistic geometry and material models

Assessment of fuel performance codes is an endeavour that requires re-evaluation as new simulation capabilities become available. BISON, the finite element-based fuel performance code in development at Idaho National Laboratory, has been used to simulate a variety of experiments. Calculations from these simulations are compared to experimental measurements for the purpose of evaluating the progress of code development. One such experiment, from the Risø 3 Fission Gas Project, provides measurements of fission gas release and clad diameter. A subset of the Risø3 Fission Gas Project, which is referred to here, consisted of a base-irradiation period of a full-length fuel rod in the Quad-Cities-1 BWR. The base irradiation test was followed by a “bump test”, in which a sub-section of the original rod was subjected to a strongly non-uniform axial power profile. The bump test took place in Risø test reactor DR3 in a water-cooled HP1 rig under BWR conditions. This experiment was chosen because it allows for an evaluation of several aspects of BISON, including fully coupled thermo-mechanics, contact, and several nonlinear material models. A summary of simulation results and comparison to the experiment data has been published previously, however, this paper shows new results with recently added features to BISON. These new features include representing the pellets as discrete entities rather than a smeared column, including primary creep in the clad creep model, and the coupling of fuel gaseous swelling to fission gas release. Comparing to previous results, the addition of theses features has narrowed the gap between BISON calculations and experimental measurements for final clad diameter and fission gas release.