Electronic stopping power of swift heavy ions in carbon

The mean stopping power of He, Be, C and Al in carbon has been studied in a continuous energy ranging from ∼100 to 800 keV per nucleon using a modified time of flight-energy elastic recoil detection analysis set-up. In order to eliminate the calibration problems of Si detectors associated with heavy ions, the time of flight section was used to measure recoil energy both before entering and after passing through the stopping foil. Consequently, the energy dependence of the stopping power was achieved with high precision. The effect of the foil thickness on the mean stopping power was investigated by tilting the stopping foil at different angles to the incoming particles to increase the effective foil thickness up to ∼22%. The stopping curves obtained at different tilting angles show a similar energy dependence with scattering less than ∼0.8% from each other, and no obvious thickness dependence is observed. Both the stopping power and the energy dependence are in good agreement with the literature data. Comparing with semi-empirical SRIM prediction, considerable discrepancies up to 6%, 10% and 8% in stopping values for Be, C and Al, respectively, are observed.