TY - GEN
T1 - A unified engineering inelastic model for 316H stainless steel
AU - Phan, V. T.
AU - Messner, M. C.
AU - Sham, T. L.
N1 - Publisher Copyright:
Copyright © 2019 ASME
PY - 2019
Y1 - 2019
N2 - Section III, Division 5 of the ASME Boiler & Pressure Vessel Code provides rules for designing high temperature nuclear components using inelastic analysis. However, the current Code does not provide guidance on suitable inelastic constitutive models to use with this design method nor does it provide Code qualified constitutive models for any of the high temperature Class A materials. This paper describes the development of an inelastic constitutive model for 316H steel, suitable for use with the Division 5 design procedures. The model captures the average response of all Code permissible 316 material as described by a large set of experimental data collected from the literature. The model uses a unified model to describe creep and rate dependent plasticity at high temperature that accounts for the experimentally-observed coupling of these deformation mechanisms. The goal is to incorporate the inelastic model developed here for 316H along with similar models for the other Class A, high temperature materials into Section III, Division 5 to facilitate the use of the design by inelastic analysis method.
AB - Section III, Division 5 of the ASME Boiler & Pressure Vessel Code provides rules for designing high temperature nuclear components using inelastic analysis. However, the current Code does not provide guidance on suitable inelastic constitutive models to use with this design method nor does it provide Code qualified constitutive models for any of the high temperature Class A materials. This paper describes the development of an inelastic constitutive model for 316H steel, suitable for use with the Division 5 design procedures. The model captures the average response of all Code permissible 316 material as described by a large set of experimental data collected from the literature. The model uses a unified model to describe creep and rate dependent plasticity at high temperature that accounts for the experimentally-observed coupling of these deformation mechanisms. The goal is to incorporate the inelastic model developed here for 316H along with similar models for the other Class A, high temperature materials into Section III, Division 5 to facilitate the use of the design by inelastic analysis method.
UR - https://www.scopus.com/pages/publications/85075829525
U2 - 10.1115/PVP2019-93641
DO - 10.1115/PVP2019-93641
M3 - Conference contribution
AN - SCOPUS:85075829525
T3 - American Society of Mechanical Engineers, Pressure Vessels and Piping Division (Publication) PVP
BT - Codes and Standards
PB - American Society of Mechanical Engineers (ASME)
T2 - ASME 2019 Pressure Vessels and Piping Conference, PVP 2019
Y2 - 14 July 2019 through 19 July 2019
ER -